top of page

Sled USA RWB on Black-01.png

Force Turbos Bypass connector for Polaris TSS. This connector allows you to bypass the throttle safety switch in your stock thumb throttle.

This product can be useful on its own, or if you are having problems with your stock Throttle Safety Switch.

This product is for Polaris sleds 2011-2024.

Force Turbos Throttle Safety Switch (TSS) Bypass

$32.99

Quantity

Begin by removing side panels & hood

Pull push pins from the plastics on the plastics located where your knees rest when seated

Remove clutch tool holding this panel to the foot plastics

Pull the plastic back being careful not to puncture the intake with the extruded piece located below the intake grate

Locate the black Velcro bag by the gas tank behind the plastic & remove the Velcro bag

This will expose the handle bar wiring connectors

Cut the zip ties from the handle bars that hold the wires to the bar on the throttle side

There are 2 other zip ties on the wiring harness downstream that need to be cut as well

Locate the 2 pin white wire connector with the blue/black & red/black wires

Unplug the connector by pushing down the nub behind the locking tab & gently pull it apart

Plug the Force Turbos TSS into the side leading to the ECU & make sure that it locks in

If installing on a stock throttle block, you can continue on in the instructions to remove the switch & wiring from the throttle block housing or just leave it & start to put everything back together by reversing previous steps

bottom of page